Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
c. Tighten a new clamp with the screw, as shown in the illustration.
15. INSTALL RIGHT-HAND AND LEFT-HAND TIE ROD ENDS AND LOCK NUTS
a. Screw the lock nut and tie rod end onto the rack end until the matchmarks are aligned.
b. After adjusting toe-in, torque the nut.
Torque: 55 Nm (560 kgf-cm, 41 ft. lbs.)
16. INSTALL 2 TURN PRESSURE TUBES
a. Install 2 new union seats to the rack housing.
b. Install 2 new union seats to the control valve housing.
c. Using SST, install the 2 turn pressure tubes.
SST 09023-38200
Torque: 23 Nm (235 kgf-cm, 17 ft. lbs.)
HINT:
^
Use a torque wrench with a fulcrum length of 300 mm (11.81 inch).
^
This torque value is effective in case that SST is parallel to a torque wrench.