Tacoma PreRunner Dbl Cab 2WD V6-3.4L (5VZ-FE) (2001)
3. Pre runner: REMOVE LOCK NUT AND ABS SPEED SENSOR ROTOR/SPACER
a. Using a chisel and hammer, loosen the staked part of the lock nut.
NOTICE: Be careful not to damage the bushing.
b. Using Special Service Tool (SST), remove the lock nut.
SST 09318-12010
c. Remove the ABS speed sensor rotor/spacer.
NOTICE: Take care not to scratch the serration of the speed sensor rotor.
4. REMOVE AXLE HUB FROM STEERING KNUCKLE
a. Remove the 4 bolts and shift the dust cover towards the hub side (outside).
b. Using SST, remove the axle hub from the steering knuckle.
SST 09710-30021 (09710-03051), 09950-40011 (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04031, 09957-04010,
09958-04011)
c. Remove the dust cover from the steering knuckle.
d. 4WD: Remove the bearing spacer and ABS speed sensor rotor/ spacer.
5. REMOVE OIL SEAL (OUTSIDE)
Using a screwdriver, remove the oil seal (outside) from the steering knuckle.
6. REMOVE BEARING FROM STEERING KNUCKLE
a. Using snap ring pliers, remove the snap ring.
b. Using SST and a press, remove the bearing from the steering knuckle.
SST 09950-60020 (09951-00810), 09950-70010 (09951-07150)
REASSEMBLY