Tacoma PreRunner Extra Cab 2WD L4-2.7L (3RZ-FE) (1998)
d. Using SST, turn the control valve shaft right and left 1 or 2 times.
SST 09616-00010
e. Loosen the cap until the rack guide spring is not functioning.
f.
Using SST and a torque wrench, tighten the cap until the preload is within specification.
SST 09616-00010
Preload (turning): 0.5 - 1.7 Nm (4.7 - 17.2 kgf-cm, 4.1 - 14.9 inch lbs.)
12. INSTALL RACK GUIDE SPRING CAP LOCK NUT
a. Apply sealant to 2 or 3 threads of the nut.
Sealant:
Part No.08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
b. Holding the rack guide spring cap rotating, and using SST, torque the nut.
SST 09922-10010
Torque: 51 Nm (521 kgf-cm, 38 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Recheck the total preload.
Preload (turning): 0.5 - 1.7 Nm (4.7 - 17.2 kgf-cm, 4.1 - 14.9 inch lbs.)
d. Remove the RH and LH rack ends.
13. INSTALL RH AND LH CLAW WASHERS AND RACK ENDS