Tacoma PreRunner Extra Cab 2WD L4-2.7L (3RZ-FE) (1998)
![background image](/toyota/tacoma_prerunner_extra_cab_2wd/l4-2.7l_(3rz-fe)/Page-1341018.png)
a. Install a new washer, and temporarily tighten the rack end.
HINT: Align the claws of the washer with the steering rack grooves.
b. Using a spanner to hold the steering rack steady, and using SST, torque the rack end.
SST 09922-10010
Torque: 76 Nm (770 kgf-cm, 56 ft. lbs.)
NOTICE: Use SST 09922-10010 in the direction shown in the illustration.
HINT: Use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
c. Using a brass bar and hammer, stake the washer.
NOTICE: Avoid any impact to the rack.
14. INSTALL RH AND LH RACK BOOTS, CLAMPS AND CLIPS
a. Ensure that the tube hole is not clogged with grease.
HINT: If the tube hole is clogged, the pressure inside the boot will change after it is assembled and the steering wheel is turned.