Tacoma Regular Cab 2WD L4-2.4L (2RZ-FE) (2000)
/Page-969004.png)
HINT: Pass the arm shaft through the bushing.
4. Check that the arm shaft turns easily, and check that there is no axial play in the arm shaft.
d. Install the lock bolts.
Position the arm shaft so that the frame installation surface is at 90° to the suspension arm as shown, and torque the lock bolts.
Torque: 125 Nm (1,270 kgf-cm, 92 ft. lbs.)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check the front wheel alignment and ABS speed sensor signal