Tundra 2WD V6-4.0L (1GR-FE) (2005)
3. REMOVE CALIPER
Remove the 2 mounting bolts and caliper.
Torque: 123 Nm (1,250 kgf-cm, 90 ft. lbs.)
4. REMOVE CLIP, 2 PINS AND ANTI-RATTLE SPRING
5. REMOVE 2 PADS AND 4 ANTI-SQUEAL SHIMS
NOTICE: The anti-rattle spring and clip can be used again provided that they have sufficient rebound, no deformation, cracks or wear, and have
had all rust, dirt and foreign particles cleaned off.
INSTALLATION
Installation is in the reverse order of removal.
HINT:
-
After installation, fill the brake reservoir with brake fluid and bleed the brake system.
-
Check for leaks.