Tundra 2WD V6-4.0L (1GR-FE) (2005)
/Page-952002.png)
NOTICE: The anti-rattle spring and clip can be used again provided that they have sufficient rebound, no deformation, cracks or wear, and have
had all rust, dirt and foreign particles cleaned off.
5. CHECK DISC THICKNESS AND RUNOUT
6. INSTALL NEW PADS
NOTICE: When replacing worn pads, the anti-squeal shims must be replaced together with the pads.
a. Draw out a small amount of brake fluid from the reservoir.
b. Press in the pistons with a monkey wrench handle or equivalent.
HINT:
-
Tape the monkey wrench handle before use.
-
Always change the pads on one wheel at a time as there is a possibility of the opposite piston flying out.
-
If the piston is difficult to push in, loosen the bleeder plug and push in the piston while letting some brake fluid escape.
c. Install the anti-squeal shims to new pads.
HINT: Apply disc brake grease to both sides of the inner anti-squeal shims.
d. Install new pads.
NOTICE: Do not allow oil or grease to come in contact with the rubbing face.
7. INSTALL ANTI-RATTLE SPRING AND 2 PINS
8. INSTALL CLIP
9. INSTALL FRONT WHEEL
Torque: 113 Nm (1,150 kgf-cm, 83 ft. lbs.)
10. DEPRESS BRAKE PEDAL SEVERAL TIMES
11. CHECK THAT FLUID LEVEL IS AT MAX LINE