Tundra 2WD V6-4.0L (1GR-FE) (2005)
/Page-984007.png)
3. REMOVE BRAKE ACTUATOR HOSE
a. Using needle nose pliers, slide the 2 clips.
b. Remove the brake actuator hose from the hydraulic brake booster assembly.
4. REMOVE BRAKE ACTUATOR TUBE NO.1
a. Using SST, remove the brake actuator tube No.1 from the hydraulic brake booster assembly.
Torque: 15.2 Nm (155 kgf-cm, 11.2 ft. lbs.)
5. REMOVE BRAKE BOOSTER W/ ACCUMULATOR
a. Using a screwdriver, remove the 2 plugs from the hydraulic brake booster assembly.
b. Remove the 2 screws and pull the wire harness from the hydraulic brake booster assembly.
Torque: 2.9 Nm (30 kgf-cm, 26 inch lbs.)