Tundra 2WD V6-4.0L (1GR-FE) (2005)
Wheel Speed Sensor: Service and Repair
Rear
REAR SPEED SENSOR
COMPONENTS
REMOVAL
1. REMOVE REAR WHEEL
Torque: 113 Nm (1.150 kgf-cm, 83 ft. lbs.)
2. DISCONNECT SPEED SENSOR CONNECTOR
3. REMOVE SPEED SENSOR
a. Remove the bolt and speed sensor from the axle carrier.
Torque: 8.0 Nm (82 kgf-cm, 71 ft. lbs.)
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check the speed sensor signal.