Tundra 2WD V6-4.0L (1GR-FE) (2005)
1. INSTALL MAGNET CLUTCH
a. Fit the parts as shown in the illustration, and install the magnet clutch stator.
b. Using a snap ring expander, install a new snap ring with the chamfered side facing up.
c. Install the screw and connect the connector.
d. Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.
e. Install the magnet clutch washer and the magnet clutch hub.
NOTE: Do not change the combination of the magnet clutch washers used before disassembly.
f.
Using SST, install the magnet clutch hub and the magnet clutch washer with the bolt.
SST 09960-10010 (09962-01000, 09963-00500)
Torque: 18 N.m (183 kgf.cm, 13 ft.lbf)