Tundra 2WD V6-4.0L (1GR-FE) (2005)
/Page-1107001.png)
Power Distribution Relay: Testing and Inspection
Component Inspection
SFI System
INSPECTION
1. REMOVE ACC CUT RELAY
2. INSPECT ACC CUT RELAY
a. Using an ohmmeter, check for continuity between each terminal.
b. Using an ohmmeter, check for continuity between terminals 3 and 5 when the battery voltage is applied across terminals 1 and 2.
Specified condition: Continuity
3. INSTALL ACC CUT RELAY
Power Outlet
Double cab (12 V):
INSPECT ACC RELAY AND ACC CUT RELAY CONTINUITY
If the continuity is not as specified, replace the switch.
Power Mirror Control System