Tundra 2WD V6-4.0L (1GR-FE) (2005)
Clockspring Assembly / Spiral Cable: Service and Repair
Removal and Installation
REMOVAL
NOTE:
-
If the wiring connector of the SRS is disconnected and the ignition switch is in the ON or ACC position, DTCs will be recorded.
-
Never use airbag parts from another vehicle. When replacing parts, replace them with new ones.
1. PRECAUTION
Refer to Air Bag Systems; Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
3. REMOVE STEERING WHEEL PAD
4. REMOVE STEERING WHEEL
5. REMOVE STEERING COLUMN COVER LOWER
6. REMOVE SPIRAL CABLE
INSTALLATION
CAUTION:
-
If the steering wheel pad has been dropped, or there are cracks, dents or other defects in the case or connector, replace the steering wheel pad with
a new one.
-
When installing the steering wheel pad, take care that it is not pinched between other parts.
-
Never use airbag parts from another vehicle. When replacing parts, replace them with new ones.
1. INSTALL SPIRAL CABLE
2. INSTALL STEERING COLUMN COVER LOWER
3. INSTALL STEERING WHEEL
4. INSTALL STEERING WHEEL PAD
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. INSPECT SRS WARNING LIGHT