Tundra 2WD V6-4.0L (1GR-FE) (2005)
/Page-1335006.png)
Split type:
INSTALL FRONT SEAT ASSEMBLY LH
8. Bench type:
INSTALL FRONT SEAT ASSEMBLY
9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
10. INSPECT SRS WARNING LIGHT
Replacement Requirements
REPLACEMENT
REPLACEMENT REQUIREMENTS
In the following cases, replace the seat position sensor assembly with a new one.
-
The seat position sensor assembly has been found to be faulty in troubleshooting.
-
The seat position sensor assembly has been dropped.
CAUTION: For removal and installation procedures of the seat position sensor assembly, see Removal and Installation. Be sure to follow the correct
procedure.