Tundra 2WD V6-4.0L (1GR-FE) (2005)
q. Remove the 4 headrest supports from the seatback assembly.
r.
Remove the seatback lock upper bezel.
s. Remove the seatback frame from the seatback pad.
INSTALLATION
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
NOTE:
-
If the side airbag assembly has been dropped, or there are cracks, dents or other defects in the case or connector, replace the side airbag assembly
with a new one.
-
When installing the side airbag assembly, take care it is not pinched between other parts.
-
Never use airbag parts from another vehicle. When replacing parts, replace them with new ones.
1. INSTALL SEATBACK ASSEMBLY
a. Install the bushing to the seatback frame.
b. Using a torx(R) socket wrench, install the seatback assembly with the 2 torx(R) screws to the seat cushion assembly.
Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)
c. Install the 3 bolts.
Torque:
Bolt A: 55 N.m (561 kgf.cm, 41 ft.lbf)
Bolt B: 21 N.m (214 kgf.cm, 15 ft.lbf)
d. Connect the front seat center belt with the 3 nuts.
e. Install the RH reclining adjuster inside cover with the 2 screws.
f.
Install the RH seat cushion lower shield with the screw.