Tundra 2WD V6-4.0L (1GR-FE) (2005)
Side Air Bag: Testing and Inspection
Side Airbag Assembly (Manual Adjuster Type)
INSPECTION
1. VEHICLE NOT INVOLVED IN A COLLISION
a. Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
b. With the front seat airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the
front seatback assembly with a new one:
Cuts, minute cracks or marked discoloration on the front seatback assembly around the front seat airbag assembly.
2. VEHICLE INVOLVED IN A COLLISION AND AIRBAG IS NOT DEPLOYED
a. Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
b. Perform a visual check which includes the following items with the seatback assembly removed from the vehicle.
-
Cuts, tears and cracks on the side airbag assembly.
-
Cuts and cracks in the wire harness, and chipping in the connectors.
CAUTION: For removal and installation of the front seatback assembly, see Removal and Installation. Be sure to follow the correct
procedure.