Tundra 2WD V6-4.0L (1GR-FE) (2005)
SIDE AIRBAG SENSOR ASSEMBLY
INSPECTION
1. VEHICLE NOT INVOLVED IN A COLLISION
Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
2. VEHICLE INVOLVED IN A COLLISION AND AIRBAG IS NOT DEPLOYED
Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
3. VEHICLE INVOLVED IN A COLLISION AND AIRBAG IS DEPLOYED
Replace the side airbag sensor assembly.
CURTAIN SHIELD AIRBAG SENSOR ASSEMBLY
INSPECTION
1. VEHICLE NOT INVOLVED IN A COLLISION
Perform a diagnostic system check .
2. VEHICLE INVOLVED IN A COLLISION AND AIRBAG IS NOT DEPLOYED
Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
3. VEHICLE INVOLVED IN A COLLISION AND AIRBAG IS DEPLOYED
Replace the curtain shield airbag sensor assembly.
SEAT POSITION SENSOR ASSEMBLY
INSPECTION
1. VEHICLE NOT INVOLVED IN A COLLISION
Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
2. VEHICLE INVOLVED IN A COLLISION
a. Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
b. Even if the airbag was not deployed, perform a visual check for damage to the seat position sensor assembly. If there are any defects
mentioned below, replace the seat position sensor assembly with a new one:
-
Cracks, dents or chips in the case.
-
Cracks or other damage to the connector.
CAUTION: For removal and installation procedures of the seat position sensor assembly, see Removal and installation. Be sure to follow the
correct procedure.
SEAT OCCUPANT SENSOR
INSPECTION
1. VEHICLE NOT INVOLVED IN A COLLISION
Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
2. VEHICLE INVOLVED IN A COLLISION
a. Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
b. Even if the airbag was not deployed, perform a visual check for damage to the occupant classification ECU. If there are any defects mentioned
below, replace the occupant classification ECU with a new one:
-
Cracks, dents or chips in the case.
-
Cracks or other damage to the connector.
CAUTION: For removal and installation procedures of the occupant classification ECU, see Removal and Installation. Be sure to follow the