Tundra 2WD V6-4.0L (1GR-FE) (2005)
Impact Sensor: Testing and Inspection
Seat Position Sensor Assembly
INSPECTION
1. VEHICLE NOT INVOLVED IN A COLLISION
Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
2. VEHICLE INVOLVED IN A COLLISION
a. Perform a diagnostic system check.
Refer to Air Bag Systems; Testing and Inspection.
b. Even if the airbag was not deployed, perform a visual check for damage to the seat position sensor assembly. If there are any defects
mentioned below, replace the seat position sensor assembly with a new one:
-
Cracks, dents or chips in the case.
-
Cracks or other damage to the connector.
CAUTION: For removal and installation procedures of the seat position sensor assembly, see Removal and installation. Be sure to follow the
correct procedure.