Tundra 2WD V6-4.0L (1GR-FE) (2005)
b. Using SST and a press, remove the bushing.
SST 09613-26010, 09632-36010, 09950-00020
c. Using SST, a press and steel plate, install a new No. 1 bushing.
SST 09502-12010, 09631-12090
HINT: Before installing the bushing, set it in the correct direction, as shown in the illustration.
d. Using SST, a press and steel plate, install a new No. 2 bushing.
SST 09631-12090, 09950-60020 (09951-00680)
HINT: Before installing the bushing, set it in the correct direction, as shown in the illustration.
2. REPLACE NO. 1 AND NO. 2 SPRING BUMPERS ON-VEHICLE
a. Remove the front wheel.
b. Using SST, replace the No. 1 spring bumper.
SST 09922-10010
HINT: At the time of installation, use a torque wrench with a fulcrum length of 345 mm (13.58 inch).
Torque: 23 Nm (235 kgf-cm, 17 ft. lbs.)
c. Replace the No. 2 spring bumper.