Venza AWD V6-3.5L (2GR-FE) (2010)
(a) Remove the 2 bolts and 2 compression springs.
(b) Remove the center exhaust pipe assembly from the 2 exhaust pipe supports.
(c) Remove the gasket from the front No. 3 exhaust pipe sub-assembly.
9. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY
(a) Disconnect the 2 clamps and heated oxygen sensor connector (for Bank 1 Sensor 2).
(b) Remove the grommet.
(c) Remove the 2 bolts, 2 nuts and front No. 3 exhaust pipe sub-assembly.
(d) Remove the 2 gaskets from the front No. 3 exhaust pipe sub-assembly.
10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
(a) Remove the 2 nuts and No. 1 exhaust pipe support bracket.