Venza FWD L4-2.7L (1AR-FE) (2009)
3. BEFORE FILLING TRANSAXLE WITH FLUID
(a) Lift the vehicle.
NOTICE: Set the vehicle on a lift so that the vehicle is kept level when it is lifted up.
(b) Remove the No. 2 engine under cover and front fender apron seal LH.
4. PERFORM INITIAL FILLING
NOTICE: If the transaxle is hot (ATF temperature is high), wait until the fluid temperature becomes the same as the ambient temperature
before starting the following procedure. (Recommended ATF temperature: around 20°C [68°F])
(a) Remove the refill plug and gasket from the automatic transaxle.
NOTICE: After performing any of the following operations, it is not necessary to perform the initial filling procedure. Proceed to the Add
Specified Amount of Fluid procedure.