Venza FWD L4-2.7L (1AR-FE) (2009)
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Text in Illustration
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 2 JUNCTION CONNECTOR -
CERTIFICATION ECU)
OK -- Continue to next step.
21. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 2 JUNCTION CONNECTOR)
(a) Reconnect the CAN No. 2 junction connector.
(b) Measure the resistance according to the value(s) in the table below.
NOTICE: The resistance must be measured after the main wire connected ECUs (ECM and combination meter), and CAN No. 1 and No. 2
junction connectors are reconnected.
Standard Resistance:
Text in Illustration