Diode V12 in Wiring Harness - Hydraulic Pump for Electric Folding Hood, Replace
 Remove, Disconnect Rear right rear quarter panelling - see operation "Rear Quarter Panelling, Rear, Remove and Install - Model 53-B" in group "C". Detach wiring harness plug with relay from relay frame. Carefully make access to diode, the anode lies towards K106, connection 87A, green wiring harness plug, green lead. Cut off diode at lead ends. | 
|
 Install, Connect Pull protective sleeve over lead ends. Solder in diode, ensure that polarity is correct (mark, cathode, points towards wiring harness). Pull protective sleeve over diode and its connections. Retape wiring harness with insulating tape. Insert wiring harness plug with relay onto relay frame. Rear quarter panelling. | 
|
|
