Rocker Arm, Replace (Cylinder Head Installed),
Hydraulic Valve Lifter, Replace (Cylinder Head, Installed)
Remove
Remove wiring trough (1) from camshaft housing.
Detach engine vent hoses (2) from camshaft housing cover.
Remove camshaft housing cover from camshaft housing.
Remove lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
|
|
Adjust
At the fastening bolt of the toothed belt drive gear, turn
crankshaft in engine rotation direction until the cam (3) of the
rocker arm/hydraulic valve lifter to be replaced assumes a vertical
position.
Remove
Place KM-565-A (1) on camshaft housing and valve spring plate
and compress valve spring.
Remove rocker arm (2) from camshaft housing – note thrust
piece.
Remove hydraulic valve lifter from camshaft housing.
|
|
Install
Insert hydraulic valve lifter in camshaft housing.
Adjust
Adjustment of hydraulic valve lifter is omitted.
Install
Coat sliding surfaces of the rocker arm with MoS 2 lubricating paste (grey) and insert in camshaft
housing – note thrust piece.
Remove
Release valve spring and remove KM-565-A.
Install
Install lower engine compartment cover – see operation
"Lower Engine Compartment Cover, Remove and Install" in group
"A".
Install camshaft housing cover with new gasket to camshaft
housing – tightening torque – 8 Nm / 6 lbf. ft.
Attach engine vent hoses to camshaft housing cover.
Attach wiring trough to camshaft housing cover and camshaft
housing.
|