|
Toothed Belt Cover, Lower Part, Remove and
Install
 Remove
|
Remove air cleaner housing – see illustration "Air Ducts X
14 XE, Z 14 XE, X 16 XEL,Z 16 XE, Z 16 YNG" or "Air Ducts X 18 XE1,
Z 18 XE, Z 18 XEL".
Remove upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Remove ribbed V-belts – see operation "Ribbed V-belts,
Remove and Install".
Remove ribbed V-belt tensioner – see operation "Ribbed
V-belt Tensioner, Remove and Install".
Lever closure plug (arrow) out of opening with screwdriver.
Insert KM-911 (1) in opening of oil pan and lock flywheel or
drive disc.
Detach increment disc (2) from crankshaft.
Remove fastening bolt (3) and unclip lower part of toothed belt
cover from rear toothed belt cover.
|
|
Install
Clip lower part of toothed belt cover to rear toothed belt cover
and fasten – tightening torque 4 Nm / 2.95 lbf. ft.
Attach increment disc with new bolt to crankshaft –
tightening torque 95 Nm / 70 lbf. ft. + 45° + 15°.
Remove Locking Tool KM-911 and insert new closure plug in
aperture.
Install ribbed V-belt tensioner – see operation "Ribbed
V-belt Tensioner, Remove and Install".
Install ribbed V-belt – see operation "Ribbed V-belt,
Remove and Install".
Install upper part of toothed belt cover – see operation
"Toothed Belt Cover – Upper Part, Remove and Install".
Install air cleaner housing – see illustration "Air Ducts
X 14 XE, Z 14 XE, X 16 XEL, Z 16 XE, Z 16 YNG" or "Air Ducts X 18
XE1, Z 18 XE, Z 18 XEL".
|
