|
Crankshaft Pulse Pick-up – EDC 15 M Engine
Management System, Remove and Install
 Remove
|
Disconnect wiring harness plug for crankshaft pick-up (1) and
set aside wiring harness.
Remove crankshaft pulse pick-up (2) from cylinder block.
|
|
Install
Attach crankshaft pulse pick-up to cylinder block with new seal
ring – tightening torque 8 Nm / 6 lbf. ft.
Connect wiring harness plug for crankshaft pulse pick-up –
ensure cable routing is correct.
|
