Remove gaskets (1) (1 unit) and (2) (4 units).
Clean
Clean all sealing surfaces.
Install
Insert new gaskets (1) and (2).
Insert multi-plate clutch assembly C1 into transmission housing
from above.
Insert 5 cut seal rings into bearing journal. Insert thrust
bearing assembly with thrust washer.
Install rear housing cover with sealing compound to transmission
housing – tightening torque 25 Nm / 18 lbf. ft.
Remove bracket assembly from KM-113-2. Remove Bracket KM-910
from transmission.
Install transmission – see operation "Transmission, Remove
and Install (AF-13 II/AF 17)".
|