Replace front member (impact absorber)
Remove
1. |
Remove front panelling
|
3. |
Detach centre guide rails
• |
Drill away 5x blind rivet (arrow)
|
|
|
|
4. |
Detach impact absorber wiring harness
|
5. |
Detach impact absorber (3)
• |
Unscrew windscreen washer reserve tank bolt (2)
|
• |
Unscrew 4x nut and 4x bolt (1)
|
|
|
|
Install
6. |
Seal cavity
Note: Observe
protective wax corrosion protection measures.
|
7. |
Attach impact absorber
Note: Use new nuts.
• |
Insert 4x bolt and tighten 4x nut 20
Nm
|
• |
Tighten windscreen washer reserve tank bolt
|
|
8. |
Attach impact absorber wiring harness
Note: Make sure that it
is correctly routed.
|
9. |
Attach centre guide rails
• |
Rivet on 5x blind rivet
|
|
11. |
Attach front panelling
|
|