Vauxhall Workshop Service and Repair Manuals

Rear Panelling, Replace (OPC and Line Pack 2) (Model L 08)

  Remove

1.	Remove right and left rear lights

2.   Remove right and left licence plate lamps (arrows) •   Unlock 2x retainer •   Disconnect 2x wiring harness plug 3.   Release rear panelling •   Unscrew 4x right-hand (2) and left-hand (1) outside bolts •   Unscrew 2x centre bolts (3)

4.   On vehicles with park pilot: release wiring harness plug (1) Note:   There is no need to remove the two licence plate lamps.

Important:   Danger of damage. Carefully disengage rear panelling from guide rails. Push side of rear panelling upwards in the guide rail area and at the same time pull outwards in direction of arrow. 5.   Detach rear panelling (1) Note:   This requires a second person •   Unclip rear panelling from right guide rail (2) •   Unclip rear panelling from rear guide rail (3) •   Unclip rear panelling from left guide rail (4)

6.   Remove decorative grille •   Unclip decorative grille, left side (2) 2x and remove from guide •   Unclip decorative grille, right side (1) 2x and remove from guide 7.   Remove reversing lights •   Unclip both reversing lights (3) 2x respectively

8.   Remove lower part of rear panelling •   Unlatch 20x tab (arrows) from guide

  Install

17.	Install right and left rear lights