Vauxhall Workshop Service and Repair Manuals

Replace folding lock linkage - L67

Important:   Operation to be carried out only by certified service operators.

  Remove

1.   Place folding top in service position •   Folding top half open •   Use special tool BO-47651-200 (1) •   Secure roof with accompanying tensioner belt (2)

2.   Open pump pressure •   Break perforation of the bulkhead wall panelling •   Carefully turn emergency actuation screw (1) to stop using a hex wrench.

3.   Remove front moulded headlining (1) •   Open velcro 2x (arrows) •   Unclip 8x clips (2)

4.   Fold down front seat 5.   Remove center roof moulded headlining (1) •   Unclip 10x clips (2) •   Remove moulded headlining

6.   Mark position of the middle of the folding roof to cinematic, both sides

7.   Detach center hinge panelling - both sides Note:   Only the left side is shown to simplify the illustration. •   Detach 3x from clamps

8.   Detach inner front hinge steel cover panelling (2) •   Drill out rivet (1) •   Dispose of remains of rivets •   Remove clamp

9.   Detach inner center hinge steel cover panelling •   Drill out 3x rivet (1) •   Dispose of remains of rivets •   Remove panelling (2) – Remove clamp

10.   Detach cylinder lock (4) Note:   Leave hydraulic pipeline attached to the cylinder (arrows). •   Detach cylinder lock – Unscrew 2x bolt (2) – Remove cylinder fastening plate (1) – Unscrew nut (3)

11.   Detach lock •   Remove lock clamp (1) from guide •   Unscrew 4x bolt Note:   For simplified representation, the positions of the screws are indicated in the removed condition. (arrows) •   Remove lock linkage (2)

  Install

22.	Adjust steel cover if needed •   Check gap