Replace luggage compartment lid hydraulic cylinder
- right side - L67
Remove
1. |
Detach luggage compartment panelling, right side
|
2. |
Open pump pressure
• |
Break perforation of the bulkhead wall panelling
|
• |
Carefully turn emergency actuation screw (1) to stop using a
hex wrench.
|
|
|
|
|
3. |
Detach cylinder rear lid (1)
• |
Detach fastening clamp (2)
|
• |
Disconnect wiring harness plug (3)
|
• |
Detach Bowden cable (5)
|
• |
Detach 2x hydraulic pipelines
– |
Slide off 2x clamps (arrows) with appropriate tool
Note: Tight
Note: Seal hydraulic
lines and cylinder against leaks using suitable aids.
|
|
|
|
Install
4. |
Attach cylinder rear lid
• |
Attach 2x hydraulic pipelines
– |
Slide off 2x clamps with appropriate tool
Note: Tight
|
|
• |
Connect wiring harness plug (right side)
|
|
6. |
Check and correct hydraulic pump fill level, function test,
test again and correct if necessary.
|
7. |
Attach luggage compartment panelling, right side
|
|