|
Window winder guide for glass
Non-destructive glass removal
- Prescribed tools such as wire cutter are in working order
- Adhesive height / width of adhesive bead should be no less than
13 mm / 8
mm
- Additional cost or damage is not anticipated until you go
outside this geometry (at vulcanized trim strips and paintwork, for
example)
- Protect heating line connections
Check paintwork
- Check paintwork after removal, particularly in the body frame
area
- Clean, prime and apply top coat to bare areas
- Make good minor surface damage with a paint stick
Note: Never use glass
primer (formation of corrosion). Glass primer is for protection
against UV light only, and is therefore only applied to the pane of
glass.
Pane of glass
- Treat new panes of glass with glass primer in the adhesive
areas
- To re-install panes of glass that have already been cut out, do
not apply glass primer to the PU vulcanization or on residual
adhesive that has been cut through (substandard adhesion)
- Apply new adhesive as per instructions, insert pane of glass
into body frame and fix in position with fabric tape.
Waiting periods
Pay attention to waiting period for window depending on type of
glass and vehicle equipment (airbag)
Tools, auxiliary equipment
- Assembly stand - normal commercial
- Wire cutter BO-46974
- Video VT 54
- Gun for EU cartridge up to 310 ml - normal commercial
- Suction lifter MK-641
- Adhesive (not electrically conductive) see delivery program
(our Parts Releases area)
- Paint stick (our Parts Releases area)
- Fabric tape
Note: Use provided
protective glasses and gloves from toolkit BO-46974
Note: Regulation /
safety: pay attention to waiting periods for vehicles with
newly-installed windows, check chapter entitled "Expiry date"
before using the adhesive
|
