Replace front seat upholstery covering – L08
/ L35 / L48 / L67 / L69 / L70
Remove
1. |
Disconnect battery
Note: Wait 1 minute for
airbag to deactivate
|
2. |
Detach front seat belt securing panel (1)
|
3. |
Detach seat belt from front seat
|
|
|
4. |
Place seat in the most forward position
|
5. |
Detach driver's seat, rear
|
6. |
Remove front seat
Note: Disconnect wiring
harness plug.
• |
Remove from the front guide
|
|
|
|
7. |
Partly detach front seat backrest panelling
• |
Detach panelling all round (I)
|
|
|
|
9. |
Remove side airbag
• |
Release and disconnect wiring harness plug
|
|
|
|
10. |
Uncover airbag cable harness
|
11. |
Detach height adjuster panel
• |
Unclip with a plastic wedge
|
|
12. |
Detach height adjuster
• |
Unscrew 2x bolt (1) and remove lever
|
|
|
|
13. |
Remove rear seat backrest aduster wheel
• |
Unclip with a plastic wedge
|
|
14. |
Detach outer panelling
• |
Remove front of panelling from guide (2)
|
|
|
|
15. |
Remove interior panelling
|
|
|
16. |
Remove central wiring harness plug for seat in vehicles with
heated seats
|
17. |
Uncover wiring harness for seat heating, if fitted
• |
Disconnect and uncover wiring harness plug (arrows)
– |
Detach 3x cable tie (1)
|
|
|
|
|
18. |
Remove front seat backrest
• |
Unscrew 4x bolt (1, 2)
– |
Remove front seat backrest
|
|
|
|
|
19. |
Remove upholstery covering
• |
Detach upholstery covering from seat frame all the way round
(arrows)
|
• |
Detach 16x upholstery clamps
|
• |
Remove upholstery covering
|
|
|
|
Install
20. |
Attach upholstery covering
• |
Position upholstery covering
|
• |
Attach 16x upholstery clamps
|
• |
Fasten upholstery covering to seat frame all the way round
|
|
21. |
Install front seat backrest
|
22. |
Lay wiring harness for seat heating, if fitted
|
23. |
Lay airbag cable harness
|
24. |
Install central wiring harness plug for seat
|
25. |
Install interior panelling
|
26. |
Install exterior panelling
|
27. |
Install rear seat backrest aduster wheel
• |
Clip in adjusting wheel
|
|
28. |
Install height adjuster
|
29. |
Install height adjuster panel
|
30. |
Insert side airbag
• |
Connect and latch wiring harness plug
Note: Ensure correct
wiring harness routing
|
|
32. |
Fasten front seat backrest panelling
• |
Fasten panelling all round
|
|
33. |
Install front seat
Note: Connect wiring
harness plug
• |
Insert into front guide
|
|
34. |
Attach front seat, rear
|
35. |
Return seat to its original position
|
36. |
Attach seat belt at front seat
|
37. |
Attach seat belt fastening panel
|
39. |
Program volatile memories
|
|