Remove and install servo motor, kinematic plate
for ECC and SAC
Remove
1. |
Disconnect battery.
Note: Only upon
replacement of servo motor.
|
|
2. |
Remove inner panelling for lower driver's side instrument panel
padding
|
3. |
Remove servo motor kinematic plate
• |
Separate wiring harness plug
– |
Release and disconnect wiring harness plug
|
|
|
|
Install
4. |
Fit servo motor kinematic plate
Note: The servo motor
can only be fitted in one position and is self-calibrating.
• |
Connect wiring harness plug.
|
|
5. |
Fit inner panelling for lower instrument panel padding
|
6. |
Connect battery.
Note: Only upon
replacement of servo motor.
|
7. |
Program volatile memories
Note: Only upon
replacement of servo motor.
|
8. |
Perform function check
|
|