Select programming dependent on the control unit which has set the trouble code (The control unit is displayed by the TECH 2 ).
ABS/TC/ESP
- Select the following control unit on the diagnostic tester:
ABS/TC/ESP
-
CIM
- Select the following control unit on the diagnostic tester:
CIM
-
DIS
- Select the following control unit on the diagnostic tester:
DIS
-
ECC
- Select the following control unit on the diagnostic tester:
ECC
-
ECM
- Select the following control unit on the diagnostic tester:
ECM
-
IPC
- Select the following control unit on the diagnostic tester:
IPC
-
EHU
- Select the following control unit on the diagnostic tester:
EHU
-
PEPS
- Select the following control unit on the diagnostic tester:
PEPS
-
REC
- Select the following control unit on the diagnostic tester:
REC
-
UEC
- Select the following control unit on the diagnostic tester:
UEC
-
UHP (Mobile Phone Portal)
- Select the following control unit on the diagnostic tester:
UHP (Mobile Phone Portal)
-
After programming successfully, check if the system malfunction is still present.
If the malfunction is still present, continue with the following tests:
|