vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
C-062 Fuse FE20 Circuit > < C-060 Fuse FE18 Circuit

Astra H

C-061 - Fuse FE19 Circuit

Test

Work Order Description

Nominal Value
T001

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Reconnect all disconnected components
  • All consumers turned off
  • Insert new component:
    FE19 Fuse
  • Ignition ON
  • Check the following component for proper operation:
    FE19 Fuse

Test okay?
Yes: No:
T002

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    A112 Control Unit - Transmission
    (Wiring Harness Connector (Front Wheel Drive, Manual-Transmission-Automatic (Easytronic) F13-5MTA/F17-5MTA) XC13 (Front Wheel Drive, Manual-Transmission-Automatic (Easytronic) M20-6MTA/M32-6MTA) XC82 )
  • Ignition ON
  • Insert new fuse FE19 and then check the fuse for proper operation.

Test okay?
Yes: No:


Result

Cause Of Fault
E001 Result: System Overload
  • A temporary current overload in the system behind fuse FE19 has occurred

Note:

In case of a temporary current overload, the cause for the blow of the fuse may be located in a circuit behind the control unit/component.

These circuits should be checked additionally for short to ground.
E002 Result: Defective Component
  • Defective component:
    A112 Control Unit - Transmission

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.

Note:

If the defective component is a control unit, the cause for the fault may be located in a circuit behind that component.
E003 Result: Short to Ground
  • Short circuit to ground between:
    X125 Underhood Electronic Module
    Socket Terminal 17 (XE3)
    &
    A112 Control Unit - Transmission
    Wiring harness connector (wiring harness side) terminal (Front Wheel Drive, Manual-Transmission-Automatic (Easytronic) F13-5MTA/F17-5MTA) 49 (XC13) (Front Wheel Drive, Manual-Transmission-Automatic (Easytronic) M20-6MTA/M32-6MTA) 5 (XC82)

or

  • Defective component:
    X125 Underhood Electronic Module

Note:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.





C-062 Fuse FE20 Circuit > < C-060 Fuse FE18 Circuit