vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

ABOUT US
C-087 Fuse FR14 Circuit > < C-085 Fuse FR12 Circuit

Astra H

C-086 - Fuse FR13 Circuit

Test

Work Order Description

Nominal Value
T001

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Reconnect all disconnected components
  • All consumers turned off
  • Insert new component:
    FR13 Fuse
  • Ignition ON
  • Check the following component for proper operation:
    FR13 Fuse

Test okay?
Yes: No:
T002

Check: Short to Ground of Voltage Supply Circuit
  • Ignition OFF
  • Disconnect wiring harness connector from:
    A146 Control Unit - Park Pilot
    (Wiring Harness Connector XC22 )
  • Ignition ON
  • Insert new fuse FR13 and then check the fuse for proper operation.

Test okay?
Yes: No:
T003

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Astra-H, Hatchback
Astra-H, Convertible
Astra-H, Station Wagon
Yes: No:
T004

Check: Vehicle Configuration

Is the following information correct for the actual vehicle?

Astra-H, Notchback
Yes: No:


Result

Cause Of Fault
E001 Result: System Overload
  • A temporary current overload in the system behind fuse FR13 has occurred

Note:

In case of a temporary current overload, the cause for the blow of the fuse may be located in a circuit behind the control unit/component.

These circuits should be checked additionally for short to ground.
E002 Result: Defective Component
  • Defective component:
    A146 Control Unit - Park Pilot

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.

Note:

If the defective component is a control unit, the cause for the fault may be located in a circuit behind that component.
E003 Result: Short to Ground
  • Short circuit to ground between:
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 1 (XR2)
    &
    A146 Control Unit - Park Pilot
    Wiring harness connector (wiring harness side) terminal 7 (XC22)

or

  • Defective component:
    X131 Rear Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E004 Result: Short to Ground
  • Short circuit to ground between:
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 1 (XR2)
    &
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 3 (XR5)
    or
    X131 Rear Electronic Module
    Wiring harness connector (wiring harness side) terminal 18 (XR1)
    &
    A146 Control Unit - Park Pilot
    Wiring harness connector (wiring harness side) terminal 7 (XC22)

or

  • Defective component:
    X131 Rear Electronic Module

Important:

Reset the concerned control unit with the diagnostic tester before replacing it. In order to do that, call up the "RESET" function from the PROGRAMMING menu of the current system on the diagnostic tester.
E005 Invalid / not supported vehicle configuration
  • The selected Checking Procedure is not valid for this vehicle configuration.





C-087 Fuse FR14 Circuit > < C-085 Fuse FR12 Circuit