Wheel Brake Cylinder, Remove and Install
Note: Repair or
overhaul of wheel brake cylinder is not envisaged for the time
being.
Remove
1. |
Top up brake fluid reservoir to "MAX" marking and seal with
MKM-558-10
|
4. |
Unscrew brake line (2)
Note: Collect escaping
brake fluid and seal apertures.
|
5. |
Detach wheel brake cylinder
|
6. |
Check brake shoes
Note: Brake shoes
contaminated with brake fluid must be replaced.
|
|
|
Install
7. |
Clean brake anchor plate and brake drum
|
8. |
Attach wheel brake cylinder to brake anchor plate 9 Nm
|
9. |
Attach brake line to wheel brake cylinder 16 Nm
|
11. |
Remove MKM-558-10 from brake fluid
reservoir
|
12. |
Bleed brake system and check for leaks
|
13. |
Correct brake fluid level so that it reaches the mark
"MAX".
|
14. |
Fit rear wheel 110 Nm
|
|