Brake Shoes of Rear Wheel Brake, Remove and
Install
Remove
|
3. |
Unhook upper withdrawing spring (4) with brake spring
pliers
|
4. |
Remove retaining clamp (2)
|
5. |
Unhook adjusting lever (3) with spring (1)
|
6. |
Remove adjusting unit (5) with thermoclip
• |
Pull brake shoes apart slightly
|
|
7. |
Twist cups of compression springs (6) on both sides with KM-346 (7) until the springs are unlocked
|
8. |
Remove front brake shoe (8) and unhook spring (9)
|
9. |
Unhook rear brake shoe (10) from parking brake cable (11) and
remove
|
|
Install
10. |
Clean brake anchor plate and coat both sides with anti-squeak
compound on both sides of the mating surfaces of the brake shoes in
the area of the arrows
|
12. |
Check wheel brake cylinder for leaks, replace if necessary
|
13. |
Check springs and fastenings for damage, replace if
necessary
|
14. |
Check brake shoes for cracks, oiling and wear, replace brake
shoes if necessary
|
15. |
Check brake drums for cracks and the mating surface of the
brake shoes for grooves - if necessary: precision turn brake drum
or replace
brake drum
|
|
|
16. |
Insert rear brake shoe in parking brake cable
Note: Before installing
brake shoes, ensure that the parking brake cable (1) is in the
guide (2) on the brake anchor plate.
|
17. |
Fit retaining pin, compression spring and plate with KM-346
|
18. |
Hook in retaining spring (4) and place front brake shoe on
guide (3)
|
19. |
Fit retaining pin, compression spring and plate for front brake
shoe
|
20. |
Insert adjusting unit
• |
Concertina star wheel (6)
|
• |
Coat thread with silicone grease
Note: Star wheel must
not stick at the end of the adjustment unit
|
• |
Insert adjustment unit with thermoclip - ensure correct
installation position (arrow)
|
|
21. |
Ensure that the spring washer (5) has been fitted before
fitting the adjusting lever.
Note: Fit new spring
washer when installing new brake shoes.
|
|
|
22. |
Fit adjusting lever (1) with spring (3)
|
23. |
Insert holding clamp (4) and fit upper withdrawing spring (2)
with brake spring pliers
|
25. |
Fit rear wheel 110 Nm
|
26. |
Adjust drum brake and parking brake
|
|
|
|