Brake Pedal, Replace (RHD)
Remove
1. |
Remove casing of steering column support tube at the top
• |
Unclip 2x from instrument panel
|
|
2. |
Remove casing of steering column support tube at the bottom
|
3. |
Release light switch centre
Note: To release the
light switch centre, press in the rotary switch (1) to position
"0", bring pressed-in rotary switch to the central position (3),
light switch centre (2) has been released.
|
|
|
4. |
Draw out light switch centre
|
5. |
Disconnect wiring harness plug for light switch centre
• |
Disconnect wiring harness plug
– |
Press down secondary fuse (2)
|
|
|
|
|
6. |
Remove panelling of lower instrument panel padding
• |
Remove panelling of lower instrument panel padding
downwards
|
|
7. |
Remove driver's side footwell panelling
|
8. |
Remove air duct, driver's side footwell
|
9. |
Detach wiring harness
• |
Disconnect wiring harness plug for brake light switch
|
• |
Disconnect wiring harness plug, pedal sensor
|
|
10. |
Remove pedal bolt from brake pedal
• |
Detach retaining spring
|
|
12. |
Remove brake pedal with bearing block
|
|
|
13. |
Detach brake light switch from mounting
|
Install
14. |
Install brake light switch in mounting
|
15. |
Install brake pedal with bearing block 20 Nm
|
17. |
Install pedal bolt for brake pedal
• |
Attach retaining spring
|
|
18. |
Attach wiring harness
• |
Connect wiring harness plug to pedal sensor
|
• |
Connect wiring harness plug, brake light switch
|
|
19. |
Install air guide, driver's side footwell
• |
Install expanding rivet
|
|
20. |
Install driver's side footwell panelling
|
21. |
Install lower instrument panel padding
|
22. |
Install light switch centre
• |
Connect wiring harness plug
|
• |
Insert light switch centre
|
• |
Lock switch to the left
|
|
23. |
Install casing for steering column support tube at the
bottom
• |
Clip in ignition switch panel
|
|
24. |
Install casing for steering column support tube at the top
• |
2x clip upper steering column support tube panelling in
combined instrument panel
|
|
|