Flywheel, Remove and Install
Remove
2. |
Remove clutch pressure plate
|
3. |
Remove flywheel (1)
Note: KM-6263 remains attached to the engine. To provide a
clearer illustration, KM-6263 is not
shown here
|
4. |
Check rear crankshaft seal ring, flywheel and starter crown
gear for damage or wear - replace if necessary
|
5. |
Clean contact surfaces on crankshaft and flywheel
|
|
|
Install
6. |
Fit flywheel
• |
Place flywheel (1) on crankshaft and align
|
• |
Tighten 6x bolt (3) 35 Nm + 30° +
15°
– |
Apply screw locking compound
|
|
|
|
|
8. |
Install clutch pressure plate
|
|