|
Lower Part of Oil Pan, Remove and Install
 Remove
| 1. |
Disconnect catalytic converter control oxygen sensor wiring
harness plug
|
| 2. |
Remove front exhaust pipe
|
| 3. |
Remove oil drain bolt
Note: Collect engine
oil
|
| 4. |
Disconnect wiring harness plug (1) for dynamic oil level
control and remove retaining ring (2)
|
| 5. |
Detach lower part of oil pan (3) from upper part of oil pan
|
|
|
| 6. |
Clean sealing surfaces and remove gasket remnants.
|
Install
| 7. |
Insert dynamic oil level control plug-in connection into upper
section of oil pan with new seal ring and fix in position with
retaining ring
|
| 8. |
Attach lower section of oil pan to upper section of oil pan
with new gasket and new bolts 8 Nm +
30°
|
| 9. |
Attach oil drain bolt to lower section of oil pan with new
gasket 10 Nm
|
| 10. |
Connect wiring harness plug for dynamic oil level control
|
| 11. |
Install front exhaust pipe with new gasket 35 Nm
|
| 12. |
Connect wiring harness plug for catalytic converter control
oxygen sensor
|
| 13. |
Route wiring harness
Note: Note routing of
wires
|
| 14. |
Top up engine oil quantity to "MAX" mark on oil dipstick
|
|
