Replace accumulator sensor
Important: When
working on the fuel system it is essential to pay attention to
cleanliness as even the smallest dirt particles can lead to faults
in engine operation or in the fuel system. Open fuel connections
must be sealed with appropriate plugs from the Opel Parts Catalogue
(catalogue number: 45 06 154 / part number: 9201697). Sealing plugs
are only intended to be used once.
Remove
2. |
Disconnect battery
• |
Detach ground connection from ground terminal
|
|
4. |
Remove rail pressure sensor (1) from accumulator
• |
Disconnect wiring harness connector.
|
• |
Unscrew rail pressure sensor
|
|
|
|
Install
5. |
Install rail pressure sensor in accumulator
• |
Tighten rail pressure sensor 70
Nm
|
• |
Fix wiring harness plug
|
|
6. |
Connect battery
• |
Attach ground connection to ground terminal
|
|
7. |
Fuel System, Check for Leaks
Important: Wear protective
goggles and protective gloves.
|
• |
Start engine.
Note: Check fuel system
for escaping fuel.
|
|
9. |
Program volatile memories
|
10. |
Programming the pressure storage sensor with Tech 2
|
|