|
Customer complaint
|
Remedy
|
|
Reduced cut-off speed
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System EDC 16C9, Z 17 DTL, Z 17 DTH
- Check the following data list parameters:
-
-
-
Function Checks
The check of the following system is only necessary, if the outside temperature is less than 0 °C (32 °F).
Actuator Tests
- Perform the following Actuator Tests:
After successful test/fault repair proceed to the next test step
|
|
|
|
Erratic engine operation, reproducible misfire
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System EDC 16C9, Z 17 DTL, Z 17 DTH
- Check the following data list parameters:
-
-
-
-
-
-
-
Function Checks
The check of the following system is only necessary, if the outside temperature is less than 0 °C (32 °F).
Actuator Tests
- Perform the following Actuator Tests:
After successful test/fault repair proceed to the next test step
|
|
|
|
Poor engine response
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System EDC 16C9, Z 17 DTL, Z 17 DTH
- Check the following data list parameters:
-
-
-
-
-
-
-
Function Checks
The check of the following system is only necessary, if the outside temperature is less than 0 °C (32 °F).
Actuator Tests
- Perform the following Actuator Tests:
After successful test/fault repair proceed to the next test step
|
|
|
|
Reduced engine performance in all operating conditions
|
The following test steps must be performed in the given order. If a fault is found in one test step, the subsequent test steps can be skipped.
Data List
- Select the following Functional System on the diagnostic tester:
Electronic Diesel Injection System EDC 16C9, Z 17 DTL, Z 17 DTH
- Check the following data list parameters:
-
-
-
-
-
-
Function Checks
The check of the following system is only necessary, if the outside temperature is less than 0 °C (32 °F).
Actuator Tests
- Perform the following Actuator Tests:
After successful test/fault repair proceed to the next test step
|
|
|
