|
Oxygen Sensor, Mixture Regulation, Replace
 Remove
| 2. |
Disconnect battery
| • |
Detach ground connection from ground terminal
|
|
| 3. |
Remove air intake pipe
|
| 4. |
Undo right front wheel
|
| 5. |
Raise vehicle by half its height
|
| 6. |
Detach right front wheel
|
| 7. |
Raise vehicle by half its height
|
| 8. |
Detach the lower engine cover and right engine splash guard
|
| 9. |
Disconnect wiring harness plug for mixture regulation oxygen
sensor (1)
| • |
Unclip wiring harness from bracket
|
|
| 10. |
Remove mixture regulator oxygen sensor (2)
|
|
|
Install
| 11. |
Install oxygen sensor mixture regulator
| • |
Tighten oxygen sensor 45 Nm
|
|
| 12. |
Connect wiring harness plug for mixture regulation oxygen
sensor
| • |
Clip wiring harness into bracket
|
|
| 13. |
Attach the lower engine cover and right engine splash guard
|
| 14. |
Lower vehicle by half its height
|
| 15. |
Attach right front wheel
| • |
Screw in 5x wheel bolts
|
|
| 16. |
Lower vehicle by half its height
|
| 17. |
Fasten right front wheel
| • |
Tighten 5 wheel bolts 110 Nm
|
|
| 18. |
Fit air intake manifold pipe 
|
| 19. |
Connect battery
| • |
Attach ground connection to ground terminal
|
|
| 20. |
Program volatile memories
|
| 21. |
Programming the oxygen sensor with Tech 2
|
|
