Spark Plugs, Remove and Install
Remove
2. |
Unclip engine wiring trough (1) from cylinder head
• |
Lay wiring trough to one side
|
|
3. |
Disconnect DIS ignition module wiring harness plug (2)
|
|
|
4. |
Remove DIS-ignition module
• |
Remove cover of DIS-ignition module in the direction of the
arrow
Note: Note arrow on
cover
|
• |
Remove from spark plugs using KM-6009
(1)
|
|
|
|
5. |
Remove spark plugs with KM-6363
|
Install
6. |
Install spark plugs with KM-6363
25 Nm
|
7. |
Install DIS ignition module (1) with KM-6009
Note: When installing a
new DIS-ignition module it is not necessary to replace the
gaskets
• |
Fit DIS ignition module cover
|
|
|
|
8. |
Connect DIS ignition module wiring harness plug
|
9. |
Clip engine wiring trough to cylinder head
|
|