|
Programming Transmission Parameters (M20 MTA)
Note: After replacing
or removing/installing the transmission and/or MTA system
components, the transmission parameters must be programmed. Ensure
that the battery is well charged. After repairing and using the
MTA-system for the first time:
The electronic control unit may only be removed and reinstalled
once. If the electronic control unit is removed again, it must be
replaced.
| 1. |
Delete fault memory |
| 2. |
Carry out test drive |
| 3. |
Read out fault memory |
Install
| 2. |
Set Transmission Parameters
| • |
Select corresponding vehicle identification
|
| • |
select "Transmission" in the "System selection menu"
|
| • |
Select "Easytronic (M20 MTA)" from the vehicle
identifications
|
| • |
Select "Control unit programming"
| – |
Select the "Clutch replaced" menu - after installing a new
clutch plate and pressure plate, central release, clutch pressure
line
|
| – |
Select "Clutch removed" - after installing the old clutch or
installing a new flywheel
|
| – |
Select "Transmission replaced (with MTA and ECU)" - after
installing a new transmission with MTA system and control unit.
|
| – |
Select "Transmission replaced (without MTA and ECU)" - after
installing a new transmission with re-installation of the MTA
system and control unit.
|
| – |
Select the "Transmission removed (with MTA and ECU)" menu -
after installing the old transmission
|
| – |
Select "Recalibrate control unit" menu for new programming of
the control unit
|
| – |
Select "Control unit replaced" menu when installing a new
control unit
|
| – |
Select "MTA with control unit replaced" menu when installing
the old transmission with new MTA system and new control unit
|
| – |
Select "MTA with control unit removed" menu when removing and
installing the MTA system
|
| – |
Select "Gearshift module with control module replaced" menu
when installing a new gearshift module with a new control unit
|
| – |
Select "Gearshift module with control module removed" menu when
removing and installing the gearshift module with control unit
|
| – |
Select "Clutch module replaced" menu when installing a new
clutch module
|
| – |
Select "Clutch position sensor replaced" menu when installing a
new clutch actuation sensor
|
| – |
Select "Shift and/or selector position sensor replaced" menu
when installing a new shift and/or selector position sensor
|
| – |
Select "Supply unit replaced" menu when installing a new supply
unit
|
| – |
Select "Electric motor replaced" menu when overhauling the
supply unit and installing a new electric motor
|
|
| • |
Follow the remaining menu guide in TECH 2
|
|
 Remove
| 4. |
Comply with the start-up routines required 
|
|
