Transmission Housing, Replace (F17+/F17+ MTA)
Overview of Components in Transmission
Overview of MTA Components
Remove
|
2. |
Attach transmission to KM-6115
(2)
|
3. |
Attach transmission to KM-113-2 (1)
using KM-6115
|
|
4. |
Remove left engine damping block bracket
|
5. |
Put transmission into neutral
|
6. |
F17+: Remove gearbox cover (2)
Note: Shift
transmission to neutral position
F17+ MTA: Remove gearshift module
Note: Shift
transmission to neutral position
|
7. |
Unscrew reversing lamps switch (1)
|
8. |
Remove end shield cover (4)
|
|
|
|
12. |
Remove central release (5)
|
13. |
Remove pressure line (4) and pressure line fixing sleeve
(3)
|
14. |
Remove bearing for main (2) and drive shaft (1) from
transmission housing
|
|
15. |
Remove 2x axle shaft seal ring
|
16. |
Remove transmission housing form KM-6115
|
Install
17. |
Attach new transmission housing to KM-6115
|
|
18. |
Install bearings for main (2) and drive shaft (1)
|
20. |
Install pressure line (4), transmission housing, pressure line
fixing sleeve (3)
|
21. |
Install central release (5)
|
|
22. |
Attach KM-6155 to transmission.
|
23. |
Install end shield (3)
Note: Note magnet.
|
24. |
Attach end shield cover (4)
|
25. |
F17+: Install gearbox cover (2)
F17+ MTA:
|
26. |
Fit reversing lamp switch (1)
• |
Tighten reversing lamp switch 20
Nm
Note: Use new seal
ring.
|
|
|
|
27. |
Install 2x axle shaft seal ring
|
28. |
Install left engine damping block
|
|
29. |
Detach transmission from KM-113-2 (1)
using KM-6115 (2)
|
30. |
Detach transmission from KM-6115
|
|
|