vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Vacuum Pump Assembly Replacement > < Manifold Absolute Pressure Sensor Replacement

Glow Plug Control Module Replacement

Removal Procedure

1. Open the hood.
2. If equipped, remove battery cover.

           2191705



3. Disconnect the 2 wiring harness plugs (3).
4. Remove the glow plug control module (1) by loosen the 2 retainer clips (2).

Installation Procedure


           2191705



1. Install the glow plug control module (1). Slide the glow plug control module (1) to the 2 retainer clips (2) until they audible engage.
2. Connect the 2 wiring harness plugs (3).
3. If equipped, install battery cover.
4. Close the hood.

Vacuum Pump Assembly Replacement > < Manifold Absolute Pressure Sensor Replacement