vauxhall Workshop Repair Guides

Vauxhall Workshop Service and Repair Manuals

Turbocharger Oil Feed Pipe Replacement > < Belt Idler Pulley Replacement

Generator, Air Conditioning Compressor, and Power Steering Pump Belt Replacement

Special Tools

•  EN-913-A   Installation Wrench
•  EN-48952   Tensioner Spring Holding Pin

For equivalent regional tools, refer to Special Tools .

Removal Procedure

1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .

           2191828


2. Release tension from the generator and air conditioning compressor belt.
  •  Install EN-913-A   wrench (1) to the tensioner bolt (2).
  •  Push tensioner clockwise until EN-48952   holding pin can be installed to the bore.
3. Remove the EN-913-A   wrench (1).

           2191731


4. Remove the generator and air conditioning compressor belt (1)

Installation Procedure


           2191731


1. Install the generator and air conditioning compressor belt (1)

           2191828


2. Bring tension to the generator and air conditioning compressor belt.
  •  Install EN-913-A   wrench (1) to the tensioner bolt (2).
  •  Push tensioner clockwise until EN-48952   holding pin can be removed.
3. Let the EN-913-A   wrench slowly slide anticlockwise to bring tension to the generator and air conditioning compressor belt.
4. Remove the EN-913-A   wrench .
5. Install the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
6. Close the hood.

Turbocharger Oil Feed Pipe Replacement > < Belt Idler Pulley Replacement