Clutch Actuator Cylinder Front Pipe Replacement (Left Hand
Drive - F17 MDG, M7Q, M26)
Removal Procedure
2. |
Remove radiator surge tank
clip (2). |
3. |
Remove radiator surge tank (1)
and lay aside. |
4. |
Place basin underneath.
|
5. |
Clip clutch actuator cylinder
front (1) pipe out of 2 retainers (arrows). |
6. |
Remove 2 BPMV bracket bolts
(1). |
7. |
Open retaining clip
(arrow). |
8. |
Disconnect clutch actuator
cylinder front pipe (1) from clutch master cylinder. |
9. |
Open retaining clip
(arrow). |
10. |
Disconnect clutch actuator
cylinder front pipe (1) from clutch actuator cylinder pipe
elbow. |
|
Note: For removal of
clutch actuator cylinder front pipe lift BPMV bracket
carefully.
|
11. |
Remove clutch actuator
cylinder front pipe. |
Installation Procedure
|
Note: For
installation of clutch actuator cylinder front pipe lift BPMV
bracket carefully.
|
1. |
Install clutch actuator
cylinder front pipe. |
2. |
Connect clutch actuator
cylinder front pipe (1) to clutch master cylinder. |
3. |
Close retaining clip
(arrow). |
4. |
Connect clutch actuator
cylinder front pipe (1) to clutch actuator cylinder pipe
elbow. |
5. |
Close retaining clip
(arrow). |
6. |
Install 2 BPMV bracket bolts
(1) and tighten to 20 N·m (15 lb ft)
. |
7. |
Clip clutch actuator cylinder
front (1) pipe into 2 retainers (arrows). |
8. |
Install radiator surge tank
(1). |
9. |
Install radiator surge tank
clip (2). |
|